D&B D6 Specifications download pdf (Page 30)

2.6.4 Further messages

The following messages are intended for information on the status of

the D6. They are no error messages.

Standby: indicates that the device is in standby mode.

Unlock: Press knob 2s: indicates that the device has been locked

to protect it against accidental or unauthorized operation. Press and

hold the encoder for a minimum of 2 seconds until "Lock" disappears

from the lower status line of the LCD.

2.7 System Reset

Note:

Following a system reset operation all user settings of the device are

lost except for the "dbCAN Id".

- Switch off the unit.

- Press and hold down the MUTE A switch while switching on the

power supply to the unit again.

The following "Reset screen" is displayed:

All Settings have been

reset to factory defaults

Press A again to reboot

dbCAN active Id 0.01

- Release the MUTE A switch and press the MUTE A switch again.

The unit will restart and is ready for operation.

D6 Software manual (Firmware V1.x.x) (1.3 EN) Page 30 of 32

1 2 ... 25 26 27 28 29 30 31 32

No comments

D&B D6 Specifications Page 30